House Connection Testing System with Air (without RPS03 Measuring Device)

Leak Testing System with Air For positive pressure and negative pressure testing of pipelines up to 200 mbar. DIN EN 1610 DIN 1986-30 DWA A-139 Suitable as an extension or supplement to existing test bladders. The required measurement accuracy according to DIN EN 1610 has been verified by expert report. Note: No data logger function! Recording is done directly via the AquaDP software. The software for Aquametrics products is currently only available in German. If this is a concern, our technical customer support team is happy to assist you. Advantages For measuring overpressure, underpressure and differential pressure Six differential pressure ranges from precision manometer Barometric pressure sensor and temperature compensation for highly accurate readings Large TFT color display (W × H: 45 × 60?mm) Measurement display in 9 different units: mbar, Pa, hPa, kPa, mmWS, mmHg, inWC, psi, bar Fully automatic device check, manual and automatic zero-point adjustment on program start Our tests are conducted according to the standards: DIN EN 1610, DWA-A 139, DIN 1986-30, DWA-M 149-6.Scope of Delivery Measuring device with power supply and data cable Calibration certificate Protective device cover with magnet Software (in German) on USB memory stick Bluetooth dongle for data transfer Aluminum transport case Maintenance and Service Depending on the operating conditions, checking the measurement system is absolutely necessary. The recalibration interval depends on the specific application conditions (e.g., separator inspection). Recommended recalibration interval: 1 year. Deposits on the ceramic membrane can lead to signal changes. In such cases, the ceramic membrane can be carefully cleaned of deposits using a commercially available descaler and a brush or soft bristle brush. Afterwards, rinse with cold water.