Leak Testing System (BPS03 GI by Aquametrics) Separator Inspection as Part of General Inspection

Aquametrics Leak Testing System (BPS03 GI)/ Separator Inspection as Part of General Inspection

Fields of Application

Water level testing (e.g., fill level test or water level measurement) as well as leak testing of pipelines, manholes, and separator systems such as oil or gasoline separators.

Leak tests on grease separators can also be performed quickly and easily.

Note: The software for Aquametrics products is currently only available in German. If this is a concern, our technical customer support team is happy to assist you.

Applicable Standards

• DIN 1986-30:2012-02
• DIN EN 1610
• DWA A-139

The high measurement accuracy of our level probe has been tested and certified by TÜV Rheinland / LGA in Würzburg. A corresponding test certificate is included.

Software

The AquaDP software is offered as a single-user solution (currently only in German). It includes modules for separator inspection and water level measurement (Wasser + GI).

Suitable for Separator Systems According to:

• DIN 1999-100
• DIN 4040

Your Advantages

• Highly accurate measurement results – even at low immersion depths
• Level probe with capacitive measurement principle
• Durable ceramic measuring cell with pressure and temperature compensation
• Direct use in wastewater possible
• Probe extension via chain (instead of pipe guide)
• Probe head can also be used separately without a stand
• Usable up to 10 m immersion depth without damage (overload protection up to 300 mbar)
• Supports connection of up to 4 probes simultaneously (optional)
• Optional EX-protected version available
• Coarse particle filter included as attachment in the case set
• Very robust height adjustment with plastic screw fitting – ideal for use on construction sites
• Simple USB connection to PC or tablet
• USB power supply directly from the device
• Low power consumption – long operating time

Testing According to the Following Standards:

• DIN EN 1610
• DWA-A 139
• DIN 1986-30
• DWA-M 149-6 (formerly ATV-M 143-6)
• DIN 1999-100
• DIN 4040-100
• DIN EN 805
• DVGW-W400

Maintenance and Service

Depending on the operating conditions, checking the measurement system is absolutely necessary. The recalibration interval depends on the specific application conditions (e.g., separator inspection). 

Recommended recalibration interval: 1 year.

Deposits on the ceramic membrane can lead to signal changes. In such cases, the ceramic membrane can be carefully cleaned of deposits using a commercially available descaler and a brush or soft bristle brush. Afterwards, rinse with cold water.